10 minute DIY

Here is a quick and simple DIY that you can do in 10 minutes!

Tattoo Decorated Glass


You will need:

• An old jar/glass candle holder (mine is an old Nutella jar - of course!)
• Temporary tattoos - mine are from MeriMeri 
• A cloth/kitchen paper
• Clear varnish/ModPodge

First of all, ensure your container is clean and dry - rubbing alcohol wipes are great for this.


Follow the tattoo instructions and apply them to your glass as you would to your skin - this normally involves peeling off the backing, applying the tattoo to the surface and dabbing it with a wet cloth. This will take about 30 seconds.


Slowly remove the backing paper and dab off any water gently with kitchen paper.


To protect the design, apply some matte varnish, ModPodge or similar with a small paint brush.

I wouldn't recommend popping it into the dishwasher but may be okay if gently hand washed. These are ideal as small vases and tealight holders :)


Have a great weekend :)

Customising with Heat n Bond

Another great little product I’ve tried out is the ‘Heat n Bond’ iron-on ultra hold adhesive.

'No sew’ tutorials suggest using an adhesive of some kind – I’m not keen on using hot glue as it’s messy and, erm, hot, but this non-sticky paper adhesive is great especially if you’re not confident at sewing. 

If you go ahead and buy Heat n Bond, be careful when you open the packaging – don’t just rip it open like I did as the instructions on how to use it are on there! Just snip the top off :)

Here is just one idea for its use:

Customised Canvas Bag

For this diy, you will need...

• A canvas bag
• Heat n Bond
• Scissors
• Fabric
• Pencil
• Iron

1. Pre-wash all materials without fabric softener (if using clothing) - with a canvas bag, I wouldn't bother (I found it made the bag crumple and go deformed)
2. Pre-heat your iron to about a medium setting (no steam) - place the adhesive side of the Heat n Bond onto the back of your fabric (paper liner should be facing up as you'll need to draw on this side)

3. Place and hold your iron on the paper for a few seconds - repeat all over your fabric until bonded. Allow to cool (this won't take long)

4. Draw the shape desired with a pencil and cut

5. Decide where you want to place your shapes and peel off the paper backing - press and hold the iron for about 8 seconds on each section until bonded to the bag (this may take longer with a thicker fabric)

And there you have it - a customised canvas bag. If you want to use Heat n Bond on clothing, buy Heat n Bond Lite and use a sewing machine's "zigzag" setting to sew around the edge.

Happy Sunday guys :)